Troubleshoot Holms 300

Problems CauseAction
The main brushThe main brush rotates only when the side broom is lifted.Drive broken one side. Wedge to one engine defective.Replace wedge.
The main brush spins too slowly.Low oil flow.Run the load machine on a lower gear, higher rpm, more oil flow.
Side brushThe side brush spins too slowly. Radio control setting.Press the transmitter's button 2 to increase/decrease the speed. Press and hold-blinks fast = increases speed, blinks slowly = decreases speed.
Side brush goes down in step, "bounces" down. (Applies to machines with serial number 5345-13926). Machine uplifting, transport position.The attachment must be in running mode (working position) when the side brush is started.
Side brush goes down in step, "bounces" down. (Applies to machines with serial number 5345-13926). No brush mountedInstall the brush. (Does not go down without the brush).
Side brush goes down in step, "bounces" down. (Applies to machines with serial number 5345-13926). Valve RVEB sheaves.Loosen a little on the valve. (Too tight tightened)
Side brush goes down in step, "bounces" down. (Applies to machines with serial number 5345-13926). Valve RVEB has too high pressure on the setting.Loosen the sealing, reduce pressure setting about ½ laps.
Side brush goes down in step, "bounces" down. (Applies to machines with serial number 5345-13926). The brush bumps into ground, rotating backwards.Lift the machine higher during transport.
Side brush goes down in step, "bounces" down. (Applies to machines with serial number 5345-13926). Tray missing on lift cylinder.Replace with four pieces of feathers.
Radio controlThe plug while driving.Loose contact.Check the trailer contact. Use any contact spray.
The remote control stops working.Moisture problems in the electronics.Check that the electric box on the implement is full, check that there is no moisture on the inside of the box lid. Is there moisture-unscrew the lid and let dry.
If the electric box is not tight-replace box.
The Machine stops working after a few moments of use as it becomes hot. Can work again when it cools down.Short circuit in coil.Replace the coil.